onyx_ptp_interface – Configures PTP on interface
New in version 2.8.
Synopsis
- This module provides declarative management of PTP interfaces configuration on Mellanox ONYX network devices.
Parameters
| Parameter | Choices/Defaults | Comments |
|---|---|---|
| announce_interval
-
|
configure PTP announce setting for interval, Range -3-1
|
|
| announce_timeout
-
|
configure PTP announce setting for timeout, Range 2-10
|
|
| delay_request
-
|
configure PTP delay request interval, Range 0-5
|
|
| name
- / required
|
ethernet or vlan interface name that we want to configure PTP on it
|
|
| state
-
|
|
Enable/Disable PTP on Interface
|
| sync_interval
-
|
configure PTP sync interval, Range -7--1
|
Notes
Note
- Tested on ONYX 3.6.8130
- PTP Protocol must be enabled on switch.
- Interface must not be a switch port interface.
Examples
- name: configure PTP interface
onyx_ptp_interface:
state: enabled
name: Eth1/1
delay_request: 0
announce_interval: -2
announce_timeout: 3
Return Values
Common return values are documented here, the following are the fields unique to this module:
| Key | Returned | Description |
|---|---|---|
| commands
list
|
always |
The list of configuration mode commands to send to the device.
Sample:
['interface ethernet 1/16 ptp enable', 'interface ethernet 1/16 ptp delay-req interval 0', 'interface ethernet 1/16 ptp announce interval -1']
|
Status
- This module is not guaranteed to have a backwards compatible interface. [preview]
- This module is maintained by the Ansible Community. [community]
Authors
- Anas Badaha (@anasb)
Hint
If you notice any issues in this documentation you can edit this document to improve it.
© 2012–2018 Michael DeHaan
© 2018–2019 Red Hat, Inc.
Licensed under the GNU General Public License version 3.
https://docs.ansible.com/ansible/2.8/modules/onyx_ptp_interface_module.html