The BiquadFilterNode interface represents a simple low-order filter, and is created using the BaseAudioContext/createBiquadFilter method. It is an AudioNode that can represent different kinds of filters, tone control devices, and graphic equalizers. A BiquadFilterNode always has exactly one input and one output.
A string value defining the kind of filtering algorithm the node is implementing.
The meaning of the different parameters depending on the type of the filter (detune has the same meaning regardless, so isn't listed below)
type
Description
frequency
Q
gain
lowpass
Standard second-order resonant lowpass filter with 12dB/octave rolloff. Frequencies below the cutoff pass through; frequencies above it are attenuated.
The cutoff frequency.
Indicates how peaked the frequency is around the cutoff. The greater the value is, the greater is the peak.
Not used
highpass
Standard second-order resonant highpass filter with 12dB/octave rolloff. Frequencies below the cutoff are attenuated; frequencies above it pass through.
The cutoff frequency.
Indicates how peaked the frequency is around the cutoff. The greater the value, the greater the peak.
Not used
bandpass
Standard second-order bandpass filter. Frequencies outside the given range of frequencies are attenuated; the frequencies inside it pass through.
The center of the range of frequencies.
Controls the width of the frequency band. The greater the Q value, the smaller the frequency band.
Not used
lowshelf
Standard second-order lowshelf filter. Frequencies lower than the frequency get a boost, or an attenuation; frequencies over it are unchanged.
The upper limit of the frequencies getting a boost or an attenuation.
Not used
The boost, in dB, to be applied; if negative, it will be an attenuation.
highshelf
Standard second-order highshelf filter. Frequencies higher than the frequency get a boost or an attenuation; frequencies lower than it are unchanged.
The lower limit of the frequencies getting a boost or an attenuation.
Not used
The boost, in dB, to be applied; if negative, it will be an attenuation.
peaking
Frequencies inside the range get a boost or an attenuation; frequencies outside it are unchanged.
The middle of the frequency range getting a boost or an attenuation.
Controls the width of the frequency band. The greater the Q value, the smaller the frequency band.
The boost, in dB, to be applied; if negative, it will be an attenuation.
notch
Standard notch filter, also called a band-stop or band-rejection filter. It is the opposite of a bandpass filter: frequencies outside the give range of frequencies pass through; frequencies inside it are attenuated.
The center of the range of frequencies.
Controls the width of the frequency band. The greater the Q value, the smaller the frequency band.
Not used
allpass
Standard second-order allpass filter. It lets all frequencies through, but changes the phase-relationship between the various frequencies.
The frequency with the maximal group delay, that is, the frequency where the center of the phase transition occurs.
Controls how sharp the transition is at the medium frequency. The larger this parameter is, the sharper and larger the transition will be.
From the current filter parameter settings this method calculates the frequency response for frequencies specified in the provided array of frequencies.