126.96.36.199 RESET MASTER Statement
Use this statement with caution to ensure you do not lose any wanted binary log file data and GTID execution history.
For a server where binary logging is enabled (
RESET MASTER deletes all existing binary log files and resets the binary log index file, resetting the server to its state before binary logging was started. A new empty binary log file is created so that binary logging can be restarted.
For a server where GTIDs are in use (
RESET MASTER resets the GTID execution history. The value of the
gtid_purged system variable is set to an empty string (
''), the global value (but not the session value) of the
gtid_executed system variable is set to an empty string, and the
mysql.gtid_executed table is cleared (see mysql.gtid_executed Table). If the GTID-enabled server has binary logging enabled,
RESET MASTER also resets the binary log as described above. Note that
RESET MASTER is the method to reset the GTID execution history even if the GTID-enabled server is a replica where binary logging is disabled;
RESET SLAVE has no effect on the GTID execution history. For more information on resetting the GTID execution history, see Resetting the GTID Execution History.
RESET MASTERremoves all binary log files that are listed in the index file, leaving only a single, empty binary log file with a numeric suffix of
.000001, whereas the numbering is not reset by
PURGE BINARY LOGS.
RESET MASTERis not intended to be used while any replicas are running. The behavior of
RESET MASTERwhen used while replicas are running is undefined (and thus unsupported), whereas
PURGE BINARY LOGSmay be safely used while replicas are running.
RESET MASTER can prove useful when you first set up the source and the replica, so that you can verify the setup as follows:
Start the source and replica, and start replication (see Section 16.1.2, “Setting Up Binary Log File Position Based Replication”).
Execute a few test queries on the source.
Check that the queries were replicated to the replica.
RESET MASTERon the source to clean up the test queries.
After verifying the setup, resetting the source and replica and ensuring that no unwanted data or binary log files generated by testing remain on source or replica, you can start the replica and begin replicating.